Thread the strap back up and pass it through the centre of the clip as show in photo 6.

Loop the strap around and thread it back through the end slot of the clip as shown in photo 7.

Take up the slack strap so it is placed loosely around the pack.

To pull the strap tight lock the bottom strap with one hand and pull through the slack strap with the other hand as shown in photo 8 above, as the final tension is applied the clip will roll over to lock the straps and hold the tension as shown in photo 9.

 Apply the Fliplock Clip as shown on the Fliplock Loading Instructions, tensioning the strap loosly to the pack so that the tension tool can be applied under the strap.
Leave a loose end of strapping 300mm long.

 Place the tool under the strap that passes around the packare with the tension handle fully back and down (see photo 4) to raise the strap gripper on the tool to allow the strap to lay along the lool as shown opposite.
Release the tension leaver (photo 1).

 Thread the loose strap into the tension tool passing it through the cutter and onto the capstain as shown opposite.
Position the tension tool about 100m away from the clip as shown on the photo opposite.

 Tension the strap to the desired tension using the tension handle on the tool as shown opposite (photo 2).

 At the desired tension pull the tension handle fully back and down to cut the strap from the tool (photo 3)

 Hold the tension handle fully down to release the strap gripper on the tool and remove the tool from the strap as shown in photo 4.